The preparation work before the lawn mower operation immediately endangers the service life of the lawn mower.

Before getting off the bed and working on the lawn mower, it is essential to carry out a series of regular checks and preparations. Terminate the equipment on a level position, first check the diesel fuel tank and cooling water storage tank, open the water tank cap, add an appropriate amount of cooling circulating water according to the guidelines, cover the water tank cap, open the oil cap, and add gasoline and diesel that meet the regulations. The gasoline and diesel do not need to be filled too full, cover and tighten the oil cap, check if the tire pressure is all normal, and if it is not enough, immediately inflate it, and check if the cutting disc operates normally, Is the cutting blade intact, the transmission belts of each transmission system should be free of cracks, and the clamping wheel should be working properly, otherwise it needs to be replaced or adjusted immediately. Place the transmission clutch lever and cutting clutch lever in the separation position, place the gear lever in the neutral position, loosen the cutting clamp wheel, and place it in the walking position. Place the accelerator pedal lever in the middle position, and use the crank to run the car engine. After running, slowly increase the accelerator pedal, and push the transmission clutch lever over the fusion position. Subsequently, by shifting the low gear forward, the lawn mower gradually moves around. When working in areas close to the village, the lawn mower can reach the destination station on its own. Due to the slow moving speed of this lawn mower, if the distance is far, there should also be a carrier.

When the lawn mower reaches the field, it is necessary to stop the equipment and make further adjustments. The wheelbase of the two moving wheels of this equipment can be adjusted. Let's take a look, and one side of the tire is connected to the rotating shaft through a plug. There are three connection sockets on the rotating shaft. If the tire is connected to different parts, the wheelbase of the two wheels is different. When the lawn is tilted more, the wide wheelbase can better integrate into the road surface. Move the cutting clamp wheel to the working position and adjust the cutting according to the height to width ratio of the cutting stubble. The key is to adjust the height to width ratio of the cutting according to the position of these two screws. Tighten the connecting screw of the tool head on the spindle and the connecting screw on the protective cover. Place both clutches in the disengaged position, shift to neutral position, restart the car engine, slowly increase the accelerator pedal, and gradually connect the cutting clutch rocker. The cutting disc starts to operate, integrates the transmission clutch, and then sets the low speed forward gear to neutral, gradually putting the lawn mower into operation.